...
...
...
Using the projection and microphones:
The Hope Center projection requires a laptop with an HDMI port to use the AV equipment.
There is a desk outside of the Sanctuary with an HDMI cable and two microphones. |
...
 | |
The Sennheiser microphone can be turned on by holding the red power button on the bottom. The switch on the front is to mute the microphone. You can unscrew the bottom to replace the batteries. |
|
...
|
The Shure microphone can be turned on by sliding the switch upward on the front of the microphone. You can unscrew the bottom of the microphone to replace the batteries and for more controls. |
...
| |
Directly inside the Sanctuary to the right, there is a touch panel to the left of the lights. Press the ON button to turn on the projector and the projector screen will automatically come down. NOTE: The microphones will not work if the display is not on. Turning the “Volume” knob will change the volume of the computer. Pressing the “Mic Vol” buttons will change the volume of the microphones (they need to be pressed many times to make a difference). |
...
  |
There is an HDMI port (HDMI 1 on the control panel) about knee level where you can connect a laptop with the provided cable. There is also a 3.5mm audio port for an aux connection (ex: phone, other audio device). |
...
 |
...
There is an HDMI cord upstairs (HDMI 2 on the control panel) above the glass lectern. |  |
The following steps will allow you to begin a presentation:
|
...
|
|
If the Hope Center's control panel is unresponsive and if the problem occurs again, simply use the projector remote to turn the projector off. Then, using the buttons on the control panel on the wall, restart it by turning it on from there. As a result, the screen will lower as it should, and the buttons on the control panel will be responsive once more. |
...
|