...

Lincoln Room

...

Skylight Room

...

Oak Room

...

Room Audio

• To turn on the equipment, press the big red switch, located at the top of the AV cabinet

...

Room Audio

• . (outlined in red)

...

Combining / Separating Audio

...

• Point the switch, outlined in red, UP, to combine audio in the Lincoln and Skylight rooms.

  • If its pointing down, this will separate the audio for Lincoln and Skylight.

• Point the switch, outlined in gold, UP, to combine audio in the Skylight and Oak rooms.

  • If its pointing down, this will separate the audio for Skylight and Oak.

Amplifiers

• There are two sets of amplifiers for each room. Each room has a:

  • TOA Electronics M-900MK2 8-Channel Mixer & Pre-Amplifier

  • Crown CTs 600

• To produce audio in a room, both of these need to be turned on for each room.

...

Amplifier Order

• The Lincoln Room amplifier is on top and is #1.

• The Skylight Room amplifier is in the middle and is #2.

• The Oak Room amplifier is on bottom and is #3.

...

Amplifier Light Meanings

• When the amplifier is turned on, the power light will be illuminated green. (outlined in red)

  • To send audio to all three rooms, all three amplifiers have to be turned on.

  • If you only need audio to one or two rooms, you only need the appropriate amplifier turned on.

• When the amplifier is receiving signal from an input the signal light will be illuminated green. (outlined in gold)

Amplifier controls

• The master volume knob can raise/lower the audio output from all of the input sources for that amplifier. (outlined in green)

  • To send audio to all three rooms, all three amplifiers Master Volume knobs have to be turned up.

• Bass Knob: Leave in middle.

• Treble Knob: Leave in middle.

• Input Knobs: Only turn on the one(s) that is necessary.

  • On each amplifier, the following is true:

    • Inputs 1 and 5 are the volume knobs for the 1/4” stereo ports in each room. (These can be found in each room and are labeled to the appropriate knob.)

    • Input 2 is the volume for the CD player in each room.

    • Inputs 3 and 4 are the volume knobs for the XLR ports in each room. (The ports are labeled to the appropriate knob.)

  • Input 6 / 7 / 8 are not in use for these rooms.

...

Note: No controls available

...

• • (Leave off)

Audio Ports

Note: Aux 1 port is not working in the Lincoln Room.

Note: Mic 6 port is not working in the Oak Room.

...