| Anchor | ||||
|---|---|---|---|---|
|
...
#5 - Document Camera
#6 - Guest VGA
#7 - DVD/ VHS
#8 - Not in use
Room Audio
Note: Make all audio adjustments on the main PC first.
Click the speaker icon (outlined in red).
Drag the slider on the bar left to turn down and right to turn up the volume (outlined in green).
...
The computer volume is muted if you see the speaker icon with an “x” next to it (outlined in red/green).
To unmute the computer, click the speaker icon with the “x” that is outlined in green.
Amplifier
Red highlighted button: This button can power on or power off the amplifier. Turn it on for any audio needs.
Greenhighlighted button: It is the master volume knob and can control all audio output from all sources.
...
Input Knobs: Only turn on the one that is necessary.
Input 1: Main PCAll audio
Input 2: Not in use (leave off)
...
Input 5: Not in use (leave off)
Input 6: XLR MicrophoneNot in use (leave off / XLR)
Input 7: Video SwitcherNot in use
Input 8: Guest AudioNot in use
VHS Player
...
Turn on the VHS player by pressing the power button(highlighted in red).
Press the eject button (highlighted in green).
Close the tray using the eject button.
Hit play (highlighted in gold).
...
Sony DVD / Blu-Ray / Multi-Region
...
If your Disc does not play do the following:
Open the tray again and leave the disc in the tray. Once fully open press the color button to select the region. Then close the tray.
Firmware updates - Firmware updates can be done via the internet.To update players firmware; go to the home menu, then setup menu, and then go to Software update. You must have the player connected to the internet. Click on Update Via Internet and if there is a new firmware the player will automatically update. DO not turn the player off while it is updating.
Document Camera
...
...
Front Projector
Point the remote at the projector.
Turning on the projector: Press “On” once (outlined in red).
Turning off the projector: Press “Off” twice (outlined in green).
To turn on the projector, press the power button (outlined in red) once while pointing the remote at the front of the projector.
...
Projector
If you receive a “no input message”, check that you are on HDMI #1 by pressing “Source Search” on the projector remote.
To turn on: Press the power button once. Wait for the projection to load. Might take a minute.
To turn off: Press the power button, watch for the text that will show up in the projection. Press the power button again to fully turn it off.
Freeze: This button will “freeze” the projection. The display will stay the same regardless of what you do in the computer. Press the button again to “unfreeze” and the projection will go on as usual.
Source Search: Cycle through input sources on the projector. The projector will automatically detect the connection when the other device is active.
...
Projector Screen
...
...