Page Comparison

...

IMPORTANT, PLEASE READ:

• All uses of Harbach Theatre have to be approved by the theatre department.

• The Theatre department may deny your request based on availability of the space.

• The Theatre department does all of the lighting for any event.

...

Familiarize yourself with the AV Equipment

...

1. To utilize a patch panel, connect a device listed above to either the stage left / stage right / upstage panel.

   1. To connect a microphone/receiver, use ports:

      1. SL1 / SL2 / SL3 / SL4 / SL5 / SL6

      2. SR1 / SR2 / SR3 / SR4 / SR5 / SR6

      3. US1 / US2 / US3 / US4

   2. To connect a headset, use ports:

      1. ICOM A / B

   3. To connect a speaker, use ports:

      1. SLA / SLB

      2. SRA / SRB

      3. US1 / US2 / US3 / US4

2. In the audio booth, connect from the patch panel to the mixer.

   1. Use a XLR cable from the patch panel port you selected on stage: SL / SR / US

   2. Connect the other end of the XLR cable to the appropriate port on the mixer or ICOM system.

      1. If you are using a microphone/receiver on stage, you would connect these to an input on the mixer.

      2. If you are using a headset, you would connect this to one of the ICOM boxes found around the booth.

      3. If you are using a speaker on stage, you would connect this to an output on the mixer.

3. Note: It is helpful to use white tape to label the input/output faders on the mixer so you know which microphone/speaker is which.

   1. Try to use an order that makes sense.

      1. If you connect from SL1 / SL2 / SL3, use inputs 1/2/3 on the mixer in the same order.

...

https://www.allen-heath.com/media/SQ6_AP11349_Introduction_issue2.pdf

...

Room Audio

Note: The power supply must be turned on.

Note: The following devices must be turned on for any audio to be produced in the theater.

Sound Processor

...

Amplifiers

...

Projection

INSERT IMAGE OF PROJECTOR HERE, including location and basic items for useThe projector is commonly located in the Audio/Lighting booth.

You will need the projector power cord, an extension cord, and an HDMI cable to use the projector.

...

For projection, you will need to find this table. It is usually located in the back of the stage. Place the table over the top back row of seats in the main room.

...

Projector Screen

The projector screen is the large white surface near the back of the stage. To use it, you will have to move all other curtains out of the way, as shown below.

...