• Controls lights in areas that are not the elevated stage.

• These are located next to the door all the way in the back of the room in Figure 1 above or from where the picture was taken from in Figure 2.

• Power Bar

• Microphone Receivers

• Video Switcher (to change projection inputs)

• Audio Amplifier

• Drawer with remotes and necessary cables

• DVD player

• Projector remote

• DVD Player remote

• HDMI Cable

• VGA Cable

• 3.5mm Audio jack

• 2 Wireless Microphones

Power Supply

Wireless Microphones

• Turn on: Hold the red power button at the bottom of the microphone.

• Turn off: Hold red power button.

• Volume: Change volume of respective microphone through the Audio amp in the AV Cabinet.

Amplifier

Video Switcher

• The video switcher helps select between multiple incoming video sources.

• For projection make sure the power is turned on for the switcher. The green switch located on the left should have the “I” pressed in for it to be turned on. If the “O” is pressed in, the video switcher is turned off.

• Identify the correct input number for your device connection and select it.

Wall plate Connections

• The wall plate for video inputs is on the right corner of the stage.

• Cables to connect a device can be found in the AV Cabinet Drawer.

• HDMI input is #6 in the switcher. This cable alone will project screen and audio.

• VGA input is #7 in the switcher. You will also need the audio jack connected to your device in order to project with sound.

*Use the switcher to change from one input to another.

DVD Player

• Turn on/off by pressing the power button on DVD remote.

• Choose input #8 on the switcher to project.

• Continue using the DVD player as usual.

*Remember to turn projector off before turning off the DVD player.

• Turn on: Press the power button on the remote once. Wait for the projection to load. This step may take a minute.

• Make sure the correct input has been chosen on the video switcher in the cabinet.

• Connect the appropriate cable to the device via the wall plate on the right corner of the stage.

• Turn off: Press the power button, watch for the text that will show up in the projection. Press the power button again to fully turn it off.

• Disconnect your device.

• Return the cables and projector remote to the AV Cabinet drawer.

Projector Screen